Parameter Byte Dynamic
Name
Len Default Short Description
Triggered
Playlist
570 S570 100 Path to remotely triggered playlist.
One file from the playlist is played and
then playback returns to the standard
URL1-3. Has lower priority than Priority
message.
Can be used i.e. for advertisement.
See section 5.3 Triggered Message
Playback for more details.
Volume
Offset
677 B677 1 0 Output volume of the device can be
offset to adjust the encoder-decoder
path to 0dB.
The Volume Offset is in dB units,
stored in Setup as the value+128. E.g.
+3dB offset is stored in Setup as 131.
The Setup value 0 has a special
meaning “auto”. "Auto" presets the
gain automatically according to the
hardware.
Decoding
Speed
Correction
680 i680 2 0 Decoding speed correction factor in
ppm (parts per million). This value is
signed and allows fine tuning of the
playback speed.
A negative correction slows down the
decoder, a positive value speeds up
the decoder.
NOTE: On Exstreamer 100, 110 and
200 a 48kHz audio stream/file can not
be speeded up any more (can be only
slowed down).
Maximum
Bitrate
682 W682 2 0 Maximum desired bitrate in kbps for
multi-bitrate streams.
0 (default) means receive the highest
available.
UDP
Reporting
port
684 W684 2 0 UDP port where the device reports its
Barimon status. 0 means disabled.
SNMP
Target
Trap IP
address
686 B686,
B687,
B688,
B689
4 0.0.0.0 SNMP Target IP (0.0.0.0 for disable
SNMP)
Update
Period
690 W690 2 720 Period in minutes how often to poll
update information from a remote
server. Range 1...1000. For further
details see chapter 9 Remote
Configuration and Update interface.
BARIMON
Period
692 W692 2 5 Period in minutes how often to send
device's status to the BARIMON server.
Allowed values are in range 1...1000.
For further details see chapter MTELL.
Stream
Check
Period
694 W694 2 1 Period in seconds how often the
stream sources are checked for
availability. Allowed values are in
range 1...65535
BARIX AG | 16/63
Komentáře k této Příručce